Back to Blog
Deskcnc probe6/12/2023 ![]() I calibrated it For Z touch off but I can not run the radius calibration with out errors. is The TS works only in single set manual option. ![]() I assume I could link single feature calls together wit Z moves in between to accomplish this all together ? I have a call for inside pocket that works good and the calibration for outside worked but no p9023 a. not sure if thats normal or a big problem.Īlso I would like a quick code call for outside features xyz. It works but doesn't say "0" on DRO readout when set. ![]() However the probe sets work offset G54 in the negative on the DRO then its balanced out on the offsets page. I do not have VQC graphic display as I believe my machine software is too old. I was given the easy set macro list 40120737.0C with VQC added. I installed a MP8 probe and MI12 interface and a wired TS27r.
0 Comments
Read More
Leave a Reply. |